TECHNICAL SPECIFICATIONS
Three phase rectifier bridge module
DC load module. It includes a 20W dichroic lamp and 3W LED lamps, with independent switches.
A load management module with three independent single-phase outputs for the dynamic study of different load types
Network monitor module used to measure electrical parameters in a single phase circuit
A circuit breaker module
Fixed single phase power source rated at mains voltage with auxiliary 12 Vdc fixed regulated voltage output to power measurement modules
100Ah battery with battery protection module
Motor/generator group for the simulation of a wind turbine. Includes a three-phase permanent magnet generator of aprox. 400w.
Three-phase inverter for asynchronous induction motor drive and speed control. Rated power: 1.5 kW
Off-grid inverter module, with pure sine wave output at mains voltage.
Wind turbine charge controller with brake system.
Active DC load used in the renewable energies laboratories configurable as constant resistance or constant current.
Multifunction measurement module for wind applications: It includes four separate instruments to measure all fundamental parameters for the study of a wind-system.
A grid-tie inverter, with output at mains voltage.
Three level frame
A software developed in LabVIEW is supplied with the
Wind Energy Advanced Trainer. It is able to communicate with the main components of the modular system, in order to perform a data acquisition and processing
Optional module:
DL 9026N – Three-phase waveform acquisition module:
– Selectable single-phase AC multi-meter to measure V, I, P, Q, and S.
– Data acquisition board to observe the voltage and current waveforms of the 3 phases simultaneously with isolated input.
– Comes with data acquisition SW developed in Labview for waveform visualization.
